This repository has been archived on 2024-04-08. You can view files and clone it, but cannot push or open issues or pull requests.
deb-mbse/html/ftsc/fts-4008.html

152 lines
6.3 KiB
HTML
Raw Normal View History

<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<title>Untitled Document</title>
<meta http-equiv="Content-Type" content="text/html; charset=iso-8859-1">
</head>
<body>
**********************************************************************<br>
FTSC FIDONET TECHNICAL STANDARDS COMMITTEE<br>
**********************************************************************
<p>Publication: FTS-4008<br>
Revision: 2<br>
Title: Time zone information (TZUTC)<br>
Author: FTSC<br>
Issue Date: 16 May 2003<br>
Review Date: 16 May 2005<br>
Obsoletes: FTS-0010.001<br>
----------------------------------------------------------------------<br>
Contents:<br>
1. Introduction<br>
2. Scope<br>
3. Current practice<br>
4. Control paragraph specification<br>
5. Time zone table<br>
6. Examples<br>
A. References<br>
B. History<br>
----------------------------------------------------------------------</p>
<p><br>
Status of this document<br>
-----------------------</p>
<p> This document is a Fidonet Technical Standard (FTS), issued by the<br>
FTSC for the benefit of the Fidonet community.</p>
<p> This document is based on the FSP-1001 proposal by Odinn Sorensen,<br>
2:236/77.<br>
<br>
This document is released to the public domain, and may be used,<br>
copied or modified for any purpose whatsoever.</p>
<p><br>
1. Introduction<br>
---------------</p>
<p> Current practice in FidoNet is to transmit message times in local<br>
time. This document specifies a standard for transmission of time<br>
zone information in FidoNet messages, in the form of a control<br>
paragraph (also known as a &quot;control line&quot; or &quot;kludge&quot;) named
TZUTC.</p>
<p><br>
2. Scope<br>
--------</p>
<p> This standard is specified for the transmission of FidoNet messages<br>
in any form where time zone information is not integrated into the<br>
transport format, specifically any form where the information would<br>
be lost if not transmitted in a control paragraph, eg. Type 2 packed<br>
messages. [1]</p>
<p><br>
3. Current practice<br>
-------------------</p>
<p> Some control paragraphs already exist to specify the time zone of<br>
messages, notably &quot;TZUTC&quot; and &quot;TZUTCINFO&quot;. From observations
of<br>
these control paragraphs in actual messages, TZUTC and TZUTCINFO are<br>
identical except for the name. TZUTCINFO is probably named after<br>
the JAM message base's [2] subfield of the same name.</p>
<p> This document adopts the TZUTC control paragraph because is the<br>
shortest (&quot;TZUTC&quot; vs &quot;TZUTCINFO&quot;). However, software<br>
implementations should be prepared to read and interpret the<br>
TZUTCINFO control paragraph as well.</p>
<p> The TZUTC control paragraph is inserted before the message body<br>
upon initial message creation, or export from a format containing<br>
time zone information, such as the aforementioned JAM message base.</p>
<p><br>
4. Control paragraph specification<br>
-----------------------------</p>
<p> Messages which conform to this specification must add the following<br>
control paragraph:</p>
<p> ^aTZUTC: &lt;current offset from UTC&gt;</p>
<p> Where ^a is ASCII 1, 01h.</p>
<p> The offset has the format &lt;[-]hhmm&gt;, where hhmm is the number of<br>
hours and minutes, zero-padded to two digits each, that local time<br>
is offset from UTC. If local time is WEST of UTC, then the offset<br>
is NEGATIVE. See the table below for typical offsets.</p>
<p> Note that the hh in a time zone offset is not limited to a maximum<br>
of 12. This is because the International Date Line does not run<br>
exactly along the boundary between zone -1200 and +1200. The<br>
minutes part is 00 for most time zones.</p>
<p> All four digits must be present. If the offset is negative, there<br>
must be a minus ('-', ASCII 45, 2Dh) in front of the offset.</p>
<p> Implementations must NOT put a plus ('+', ASCII 43, 2Bh) in front of<br>
the offset for positive numbers, but robust implementations should<br>
be prepared to find (and ignore) a plus if it exists.</p>
<p> If local time changes as a result of, for example, daylight savings<br>
time, then the offset in the TZUTC control paragraph should change<br>
to reflect this.</p>
<p><br>
5. Time zone table<br>
------------------</p>
<p> This table gives examples of typical time zones.</p>
<p> -1000 Alaska-Hawaii Standard Time (United States)<br>
-0900 Hawaii Daylight Time<br>
-0800 Pacific Standard Time<br>
-0700 Pacific Daylight Time<br>
-0700 Mountain Standard Time<br>
-0600 Mountain Daylight Time<br>
-0600 Central Standard Time<br>
-0500 Central Daylight Time<br>
-0500 Eastern Standard Time<br>
-0400 Eastern Daylight Time<br>
-0400 Atlantic Standard Time<br>
-0330 Newfoundland Standard Time<br>
-0300 Atlantic Daylight Time<br>
-0100 West Africa Time<br>
0000 Universal Time Coordinated (UTC)<br>
0000 Greenwich Mean Time<br>
0100 Central European Time<br>
0100 British Summer Time<br>
0200 Central European Summer Time<br>
0200 Eastern European Time<br>
0800 Australian Western Standard Time<br>
0800 China Coast Time<br>
0900 Japan Standard Time<br>
0900 Australian Western Daylight Time<br>
0930 Australian Central Standard Time<br>
1000 Australian Eastern Standard Time<br>
1030 Australian Central Daylight Time<br>
1100 Australian Eastern Daylight Time<br>
1200 New Zealand Standard Time<br>
1300 New Zealand Daylight Time</p>
<p><br>
6. Examples<br>
-----------</p>
<p> ^aTZUTC: 0000<br>
^aTZUTC: 0200<br>
^aTZUTC: -0700</p>
<p><br>
A. References<br>
-------------</p>
<p> [1] &quot;A Basic FidoNet(r) Technical Standard Revision 16&quot;, Randy Bush.<br>
September 1995.</p>
<p> [2] &quot;The JAM message base proposal&quot;, Joaquim Homrighausen, Andrew<br>
Milner, Mats Birch and Mats Wallin. July 1993.</p>
<p><br>
B. History<br>
----------</p>
<p> Rev.1, 20030409: First release (revised from FSP-1001 by FTSC)<br>
Rev.2, 20030516: Corrected status; clarified Section 2 on insertion<br>
position and export practice; fixed terminology.</p>
<p>**********************************************************************<br>
</p>
</body>
</html>