Last update 09-Sep-2002

MBSE BBS Setup - Task Manager.

Introduction

The task manager is the daemon which controls the MBSE BBS. It watches semafore's and spawns programs in the background. It also watches the outbound to see if there are nodes to call. The behaviour is setup in this screen.

Edit Task Manager

Mailout   Action for semafore mailout.
Mailin    Action for semafore mailin.
Newnews   Action for semafore newnews.
Index 1   Nodelist compiler 1 for semafore mbindex.
Index 2   Nodelist compiler 2 for semafore mbindex.
Index 3   Nodelist compiler 3 for semafore mbindex.
Msglink   Action for semafore msglink.
Reqindex  Action for semafore reqindex.
ISP conn  Not in use yet!
ISP disc  Not in use yet!
Ping #1   IP address of node to ping to check the internet.
Ping #2   IP address of second node to ping to check the internet.
Max TCP   Maximum simultaneous outgoing calls over the internet.
Max Load  Max system load until processing is suspended.
ZMH start Start of Zone Mail Hour in UTC time.
ZMH end   End of Zone Mail Hour in UTC time.

Default are the original MBSE commands filled in, but you could also call shell scripts.

The two IP addresses to ping need to be IP addresses, not hostnames. This is the most reliable way to check the connection. You should enter the IP addresses of the nameservers of your own ISP here. One of these will always be up, so if one of these can be reached, the internet connection is assumed to be alive. The status of the internet connection is used to decide if it is allowed (and possible) to call TCP/IP nodes. Calling these nodes is not depending on ZMH unless the destination is not a CM node.
The max load setting decides at which system load point processing of background tasks will be suspended. The default value should be allright for machines slower then 200 MHz or with low ram. On faster machines you may set this value higher.

Taskmanager setup

BackBack to index  HomeBack to main index